Manipulate - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.5 Component editor
4.5.6

Manipulate

Manipulate action
The "Manipulate" action allows machine data to be accessed, essentially independently of
data storage in the control.
The data to be manipulated can be stored in the archive, e.g. NC data, drive data, as well as
in the HMI (display data).
Note
Selected data areas define target areas
Which target areas are displayed depends on the data areas (archive, PCU, NCU/PPU) that
were activated for use.
The data areas are defined in the project folder in the Package tab (Page 137).
If a data area is subsequently deactivated, then all of the target area nodes that cannot be
hidden due to content are shown in red.
Note
Display of the target area
● Gray - target area does not contain any data.
● Red - data in the target area is not used.
● Blue - linked data with resolution for deployment.
● Purple - linked data with resolution during runtime.
Data manipulation operations are supported in the following "target areas":
●
●
●
●
Any number of tasks can be created in the target area below the Manipulation tasks node. A
new task can be created, imported or linked via the context menu. The task name is specified
by the user; the target area can be changed at "Settings > Target area".
274
NC data
SINAMICS data
Display data
All
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE