Siemens SINUMERIK 840D sl Operating Manual page 194

Create MyConfig - Expert
4.4 Project folder
The "myArchive.arc" archive from the "myPath" folder, which is located next to the package,
is used.
The "./" prefix represents the current path in which the package file is located at the time of
execution.
Dialog view during package execution (for commissioning engineers / operators)
In this dialog you set which archive data (NC, PLC, and DRV) will be used later in the
subsequent package stages.
Note
If the "Archive area" is activated on the "Package" tab, the "System configuration" dialog must
be parameterized.
To establish communication between the NCK, the integrated CU, and the NX expansion
modules, it is necessary to import an appropriate PLC hardware configuration in the form of
an SDB archive. It is not absolutely necessary that the final hardware expansion is included
in the SDB archive, but only the information valid for this NCU with regard to PROFIBUS,
PROFINET, NCU and NXs.
Further information can be found on package execution in the Package execution (Page 405)
section.
Figure 4-30
194
System configuration - commissioning engineer / operator view
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE