Siemens SINUMERIK 840D sl Operating Manual page 199

Display associated system variables button
Clicking the
- system variables" dialog. All system variables used for "SINAMICS topology" are listed in
this dialog.
Information on the System variables·can be found in the System variables for the SINAMICS
topology dialog (Page 379) section.
Further general information on the system variables can be found in the Reference list system
variables (Page 368) section.
Dialog
More detailed information about the "Dialog" property group can be found at Package
configuration (configuring) (Page 153).
Axis-drive assignment
The following properties available for the "axis-drive assignment" are activated when the
package is executed:
Activation
Setting disabled
An Axis-drive assignment can only be defined in the Comparison topology and User-specified
topology variants because only these variants use an appropriate configuration from Topo.
As a prerequisite, this Axis-drive assignment must have been configured and activated in Topo
for the comparison or User-specified topology.
By activation, with equal rights, of the Axis-drive assignment in Topo, there is a guarantee that
not only the expert for Expert, but also the expert for Topo will agree to this assignment.
Moreover, it is possible for the project engineer for Expert and the operator during package
execution to deactivate this automatic Axis-drive assignment without having to open and edit
the topology files.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
button (Display associated system variables) opens the "SINAMICS topology
Yes
No
Yes
No
Here, you specify whether the automatic "axis-drive as‐
signment" is to be activated.
By selecting "Yes", the project engineer can block a
change of the "activation" property by the operator dur‐
ing package execution.
Create MyConfig - Expert
4.4 Project folder
199