Sinumerik Archive Comparison; General Information On The Sinumerik Archive Comparison - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Diff

3.3 SINUMERIK archive comparison

3.3 SINUMERIK archive comparison
3.3.1

General information on the SINUMERIK archive comparison

Any number of comparison objects (SINUMERIK archives or Sub files) can be imported,
displayed and compared in a SINUMERIK archive comparison.
The comparison is realized at the data level.
The SINUMERIK archive comparison supports the comparison of the following objects:
● SINUMERIK archives in PC format and in punched-tape format
● Drive archives in ASCII and ACX format
● NC/drive/display data files (INI, OPT, TEA...) in ASCII format
● Manipulation tasks of a CMC project (only the value assignments outside of script)
● Data nodes within a comparison object
The SINUMERIK archive comparison extracts the NC, drive, and display data from the
SINUMERIK archives and displays these in a structured fashion.
Unlike file comparison involving INI files, data is not compared line by line, but according to its
identifiers. If the same identifiers occur a multiple number of times, these are only displayed
once and the value of the last one that was imported is used.
The SINUMERIK archive comparison can be performed between different objects opened for
comparison, but also within one object (selective).
The comparison result is prepared in a structured fashion.
Data from the objects being compared can be copied to the clipboard and then used in other
applications (Expert, ...).
It is possible to remove or insert identifiers and change the values of existing identifiers for
SINUMERIK archives.
Diff permits the user to resave an open SINUMERIK archive with modified data as SINUMERIK
archive.
Note
In the SINUMERIK archive comparison, Diff always displays the data contained in the
comparison object if no settings were made in the comparison configuration to exclude data
(Expert list or filter).
For SINAMICS drive data, there are parameters (r or p) that can be displayed online on the
HMI. However, they are not part of an archive and therefore cannot be displayed by Diff.
24
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE