Ncu/Ppu Access (Package Execution) - Siemens SINUMERIK 840D sl Operating Manual

You can find detailed information on the dialog scripts in the section with the same name
"Dialog scripts (Page 145)".
4.4.2.15

NCU/PPU access (package execution)

This dialog page enables access to the NCU in the case of SINUMERIK 840D sl or the PPU
in the case of SINUMERIK 828D. This specifies with which control and which login data the
package should be connected for the execution.
Dialog view during the package execution (for commissioning engineers / operators)
Execution of the "NCU/PPU access" dialog page cannot be deactivated.
If, "Data areas > Use NCU/PPU" has been selected in the Package tab, this dialog page is
executed automatically when executing a package.
Further information can be found on package execution in the Package execution (Page 405)
section.
Figure 4-20
Buttons for the package execution dialogs
Information on the general buttons in the dialogs can be found at Meaning of buttons
(Page 155).
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
NCU/PPU access - commissioning engineer / operator view
Create MyConfig - Expert
4.4 Project folder
171