Siemens SINUMERIK 840D sl Operating Manual page 189
Integrate create myconfig - diff, expert, topo
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
NC archive data
The following settings are available for the "NC archive data" and are activated when the
package is executed:
Table 4-19
NC archive data
Origin of data
Setting disabled
Preselection of the offline archive
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Note
This selection can be blocked by the project engineer in order to prevent changes by the operator
during the package execution.
Initial state
If in the package configuration, "Package" > "Data areas" > "Use NCU/PPU"
has been activated in the tab, the archive data can be loaded directly from the
control with the "initial state" setting.
If the initial state is used, the archive is extracted that was located on the control
when this dialog was entered.
If the CNC software was installed beforehand, only default data is available in
the archive.
Note
No data is reset when upgrading the CNC software. The archive that is avail‐
able in the system after data migration is used.
Overall reset
If this option is used, default data is loaded and then the archive data is backed
up.
Offline archive
If this option is used, the output data for the NC area is taken from a stored
SINUMERIK archive.
Do not use
If this option is used, no output data for this area is made available by the dialog
page.
More information is provided in the notes in the Archive data transfer (package
execution) (Page 218) section.
Yes
The selection at "Origin of data" can be blocked by the project engineer via
this option in order to prevent changes by the operator during the package
No
execution.
At "Preselection of the offline archive", a SINUMERIK archive can be prese‐
lected, pasted, or inserted as link from the list.
Select an archive from the "List of the offline archives", or enter the path of a
file that is located next to the package "/<Path>/<File>",
e.g. "./NC-data.arc".
Note
If data for "Offline archive" must be entered in the step tree via components,
no SINUMERIK archive must be specified in the preselection.
Create MyConfig - Expert
4.4 Project folder
189
Advertisement
Table of Contents
