System Configuration (Configuration) - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert
4.4 Project folder
Figure 4-28
Using the "CNC software (*.tgz)" drop-down list, a file that was assigned to the package or a
file lying next to the package (prefix: "./") can be selected.
The "Browse" button allows a selection to be made from any location.
After the tgz file has been loaded, the NCU/PPU is restarted automatically.
Note
TGZ files generated using ""sc backup xyz.tgz"" or backups generated using Create MyConfig
can only be used for a new installation.
They cannot be used for an upgrade.
If a backup of CMC is used for a new installation, the archive data it contains will be imported.
Buttons for the package execution dialogs
Information on the general buttons in the dialogs can be found at Meaning of buttons
(Page 155).
4.4.2.24

System configuration (configuration)

In this dialog, specify which data of the NC, PLC (HW) and DRV subsystems is used as output
data for the package execution.
186
CNC software - commissioning engineer / operator view
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE