Siemens SINUMERIK 840D sl Operating Manual page 206
Integrate create myconfig - diff, expert, topo
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Create MyConfig - Expert
4.4 Project folder
User-specified topology
This dialog version is used for the SINAMICS topology if "User-specified topology" was
selected for the device configuration of the drives.
Figure 4-35
Performing axis-drive assignment
Setting the check mark activates automatic axis-drive assignment.
As a prerequisite, this Axis-drive assignment must have been configured and activated in Topo.
DRIVE-CLiQ wiring
The DRIVE-CLiQ wiring of the components, the activation state, the assignments of the DO
variables and additional properties are displayed in the center of the dialog page.
The three different activation states of the SINAMICS elements are:
● "0" for deactivated
● "1" for activated
● "2" for not available
The activation states in columns "K" (Component) and "DO" (Drive Object) can be interactively
adapted. Clicking the relevant cell connects the three states. The keyboard can be operated
with up/down and letters "K" and "D".
206
SINAMICS topology - commissioning engineer / operator view - example of user-specified
topology
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Advertisement
Table of Contents
