Selecting A Program For Execution - Siemens SINUMERIK 840D Operation/Programming Manual

2
10.04

2.10.2 Selecting a program for execution

-or-
-or-
Execute
-or-
-or-
-or-
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Press the "Program" softkey or the "Program Manager" key.
The directory overview is displayed.
Place the cursor on the directory containing the program that you
want to select.
Press the "Input" or "Cursor right" key.
The program overview is displayed.
Place the cursor on the required program.
Press the "Execute" softkey.
ShopMill automatically changes to "Machine Auto" operating mode
and uploads the program.
- OR -
Press the "Program" softkey or the "Program Manager" key.
The directory overview is displayed.
Place the cursor on the directory containing the program that you
want to select.
Press the "Input" or "Cursor right" key.
The program overview is displayed.
Place the cursor on the required program.
Press the "Input" or "Cursor right" key.
The selected program is opened in the "Program" operating area. The
machining plan of the program is displayed.
Place the cursor on the program block at which the program run
must begin.
Press the "Execute" softkey.
ShopMill automatically changes to "Machine Auto" manual mode,
loads the program and conducts a block search until it reaches the
selected program block (see Sec. "Entering a program at any selected
point").
Operation
2.10 Automatic mode
2
2-117