Festo CPX-P-8DE-N Series Description page 95

3. Input module CPX-P-8DE-N-...
__System overview__
CPX terminal
0: ...Module...
1
1: ...Module...
2: ...Module...
3: P-8DI-N Input NAMUR
__________________
Diag
1
Module identifier in the main menu
(module 3 here)
Fig. 3/5: Module identification of the input module on the handheld
Festo P.BE-CPX-P-EA-EN en 1209NH English
The name [ ... Input NAMUR ...] is displayed in the main menu
of the handheld for the input module. The module identifier,
e.g. [P-8DI-N], is displayed in the header.
An example is shown in the following image:
<--> OK
Please note that the [Idle mode] menu is only available if the
bus node supports idle mode parameterisation (
description). The functions [Force], [Fail safe], [Idle Mode] and
[Diagnostics] operate as normal for CPX modules.
For an extended process image:
Please note that the output bits in byte 0 of the PIO represent
the control byte of the module. A manipulation of these bits
will affect control of the counter and frequency measurement.
The process image shown under [Monitoring] and the para-
meters shown under [Parameter] depend on the setting of the
miniature switch (
Further information about the handheld can be found in the
description for handheld type P.BE.CPX-MMI-1-... .
The following image shows an example of the representations
for an input module CPX-8DE-N... .
<-
____3: P-8DI-N____
Monitoring/Forcing (M)
Diagnostics (D)
Parameters (P)
Fail safe (F)
Idle mode (I)
Module data (MD)
___________________
Back
2
Module identifier in the header of the
system sub-menu for a module
section 3.3.1).
2
->
OK
bus node
3-45