Festo CPX-P-8DE-N Series Description page 106

3. Input module CPX-P-8DE-N-...
Error message to
the bus node
Monitoring of
0 1
limit values
Error no. 9
Lower limit value
not reached
channel X
2
1
Channel-specific module parameter (switch position indicates the presetting)
2
Channel-specific error
Fig. 3/10: Principle of error handling and parameterisation for CPX-P-8DE-N.. - part 3
3-56
Channel
error LED
Module error
LED
Error no. 10
Upper limit value
exceeded
channel X
2
The respective errors are registered or the message is sup-
pressed depending on parameterisation of the module. If
transmitted to the bus nodes, errors can be evaluated by
higher-level systems - depending on the bus protocol used.
The wire break monitoring and limit value monitoring func-
tions are inactive by default.
By using the module parameter "replacement value", you can
specify whether the replacement value or the last signal
status is to be valid in a diagnostic case (
Error no. 55
Invalid process
value
channel X
2
Festo P.BE-CPX-P-EA-EN en 1209NH English
1
Tab. 3/28).