Festo CPX-P-8DE-N Series Description page 56

3. Input module CPX-P-8DE-N-...
3-6
Set the miniature switch as follows:
1. Switch off the power supplies for the CPX terminal (-P).
2. Remove the mounted connection block (
chapter, section 2.2.3).
3. Use a suitable tool, e. g. a very small screwdriver, and
carefully set the DIL switch as desired (
4. Refit the connection block (
tion 2.2.3; observe the tightening torque!).
The set process image becomes effective after switching on
the power supply again.
mounting
Tab. 3/2).
mounting chapter, sec-
Festo P.BE-CPX-P-EA-EN en 1209NH English