Electrical Connection; Description Of Cable Ports; Communication; Analog Inputs - Ingeteam Ingecon mWind Interface Installation Manual

Ingeteam Power Technology, S.A.

5.3. Electrical connection

Once the equipment has been mounted in its definitive location, and is firmly anchored in place, the next step is to
make the electrical connections.

communication

analog
inputs

5.3.1. Description of cable ports

Whilst the wind is acting on the turbine, the resistor cables could be subject to high voltages that
could be hazardous.
Never manipulate the connections without first performing the shutdown protocol explained in "4.5.3.
Manipulation work".
The Ingecon μWind Interface cable ports are located at the bottom of the enclosure. Each type is described below:
®
Communication
To connect the communication cable between the IWI and the Ingecon

Analog inputs

A general purpose analog input connector.

Auxiliary power supply

Connector for the 230 V single phase cable for the auxiliary power supply to the equipment.

Wind turbine input

Enables the connection between the wind turbine power cable and the IWI.

DC output

To connect the DC voltage power cable between the IWI and the Ingecon

Braking resistors

The Ingecon μWind Interface models are equipped with a wind turbine resistor braking system. The cable for this
®
should be passed through this cable gland.
24
ON/OFF switch
auxiliary
power supply
wind turbine
heat sink
input
µWind.
®
µWind.
®
Installation manual
brake
resistor
DC output
AAY2000IKI06