Skippedscan; Slowproctime; Starttime; Startupcode - Campbell CR300 Series Product Manual

18.2.33 SkippedScan

Number of skipped program scans (see
that have occurred while running the CRBasic program. Does not include scans intentionally
skipped as may occur with the use of
they occur. Enter 0 to reset.

18.2.34 SlowProcTime

Processing time (μs) of the last Slow Sequence scan. Time is measured from the end of the
EndScan
instruction (after the measurement event is set) to the beginning of the
(before the wait for the measurement event begins) for the subsequent scan. Calculated on-the-
fly. Updated at the conclusion of scan processing, prior to waiting for the next scan.

18.2.35 StartTime

Time (date and time) the CRBasic program started. Updates at beginning of program compile.
NSEC data type
l

18.2.36 StartUpCode

Indicates how the running program was compiled. Updated at startup. 65 = Run on powerup is
running and normal powerup occurred. 0 = Normal shutdown -1 = Restart due to a power loss. -
2 = Restart due to watchdog reset.

18.2.37 StationName

Station name stored in flash memory. This is not the same name as that is entered into your data
logger support software. This station name can be sampled into a data table, but it is not the
name that appears in data file headers. Updated at startup or when the name is changed. This
value is read-only if the data logger is currently running a program with a
instruction.
String data type
l

18.2.38 SW12Volts

Status of switched, 12 VDC terminal. On/high (true) or off/low (false) Enter -1 to set to true. Enter
0 to set to false.Updates when the state changes.
Boolean data type
l
Checking station status
ExitScan Do
and /
(p. 118) for more information)
Loop
instructions. Updated when
CardOut()
18. Information tables and settings (advanced)
EndScan
157