Radiohopseq; Radiomac; Radiomodel; Radiomodulever - Campbell CR300 Series Product Manual

18.3.58.4 RadioHopSeq

Specifies the radio channel hop sequence. This setting must match in all radios in the same RF
network. This setting can also be used to prevent radios in one RF network from listening to
transmissions of another.
Long data type
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > RF Hop Sequence
l

18.3.58.5 RadioMAC

Radio serial number.
String data type
l
Read only
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Radio MAC Address
l

18.3.58.6 RadioModel

Reports the model of the internal radio module.
String data type
l
Read only
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Radio Model
l

18.3.58.7 RadioModuleVer

Radio hardware version.
Long data type
l
Read only
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Radio Hardware Version
l
18. Information tables and settings (advanced) 175