Progname; Progsignature; Recnum; Revboard - Campbell CR300 Series Product Manual

18.2.26 ProgName

Name of current (running) program; updates at startup.
String data type
l

18.2.27 ProgSignature

Signature of the running CRBasic program including comments. Does not change with
operating-system changes. Updates after compiling the program.

18.2.28 RecNum

Record number increments when the Status Table is requested by support software. Range = 0 to
32
2 .
Long data type
l

18.2.29 RevBoard

Electronics board revision in the form xxx.yyy, where xxx = hardware revision number; yyy = clock
chip software revision. Stored in flash memory. Updated at startup.
String data type
l

18.2.30 RunSignature

Signature of the running binary (compiled) program. Value is independent of comments or non-
functional changes. Often changes with operating-system changes. Updates after compiling and
before running the program.

18.2.31 SerialNumber

CR300 series serial number assigned by the factory when the data logger was calibrated. Stored
in flash memory. Updated at startup.

18.2.32 SerialFlashErrors

Reports on the serial flash health and provides the number of errors detected in serial flash. 0 =
No errors detected. For detailed information on serial flash, see
CPU drive, web page, and data logger settings. Because flash memory has a limited number of
write/erase cycles, care must be taken to avoid continuously writing to files on the CPU drive.
66).
Serial flash memory holds the
18. Information tables and settings (advanced)
(p.
156