Revboard; Runsignature; Serialnumber; Serialflasherrors - Campbell CR300 Series Product Manual

23.2.29 RevBoard

Electronics board revision in the form xxx.yyy, where xxx = hardware revision number; yyy = clock
chip software revision. Stored in flash memory. Updated at startup.
String data type
l

23.2.30 RunSignature

Signature of the running binary (compiled) program. Value is independent of comments or non-
functional changes. Often changes with operating-system changes. Updates after compiling and
before running the program.

23.2.31 SerialNumber

CR300 series serial number assigned by the factory when the data logger was calibrated. Stored
in flash memory. Updated at startup.

23.2.32 SerialFlashErrors

Reports on the serial flash health and provides the number of errors detected in serial flash. 0 =
No errors detected. For detailed information on serial flash, see

23.2.33 SkippedScan

Number of skipped program scans (see
that have occurred while running the CRBasic program. Does not include scans intentionally
skipped as may occur with the use of
occur. Enter 0 to reset.

23.2.34 SlowProcTime

Processing time (μs) of the last Slow Sequence scan. Time is measured from the end of the
EndScan
instruction (after the measurement event is set) to the beginning of the
(before the wait for the measurement event begins) for the subsequent scan. Calculated on-the-
fly. Updated at the conclusion of scan processing, prior to waiting for the next scan.
Checking station status (p. 169) for more information)
ExitScan Do
and /
Flash memory (p. 89).
Loop
instructions. Updated when they
23. Information tables and settings (advanced) 209
EndScan