Tlsstatus; Udpbroadcastfilter; Utcoffset; Verify - Campbell CR300 Series Product Manual

18.3.53 TLSStatus

Reports the current status of the data logger TLS network stack.
String data type
l
Read only
l

18.3.54 UDPBroadcastFilter

Set to one if all broadcast IP packets should be filtered from IP interfaces. Do not set this if you
use the IP discovery feature of the device configuration utility or of LoggerLink. If this is set, the
data logger will fail to respond to the broadcast requests.
Default = 0.

18.3.55 UTCOffset

Specifies the offset, in seconds, of the data logger's clock from Coordinated Universal Time (UTC,
or GMT). For example, if the clock is set to Mountain Standard Time in the U.S. (-7 Hours offset
from UTC) then this setting should be -25200 (-7*3600). This setting is used by the NTP Server
EmailSend()
setting as well as
setting will also be adjusted by the Daylight Savings functions if they adjust the clock.
If a value of -1 is supplied for this setting, no UTC offset will be applied.

18.3.56 Verify

This setting specifies the interval, in units of seconds, that will be reported as the link verification
interval in the PakBus hello transaction messages. It will indirectly govern the rate at which the
data logger will attempt to start a hello transaction with a neighbor if no other communications
have taken place within the interval.

18.3.57 Cellular settings

Access cellular settings, using Device Configuration Utility. Clicking on a setting in Device
Configuration Utility also provides information about that setting. These settings are available for
dataloggers with integrated CELL modules.
NOTE:
A list of Settings fieldnames is also available from the data logger terminal mode using
command F.
and HTTP(), which require Universal Time in their headers. This
18. Information tables and settings (advanced) 168