Wifieapuser; Networks; Wifienable; Wifipassword - Campbell CR300 Series Product Manual

18.3.59.8 WiFiEAPUser

If joining an Enterprise Security-enabled network enter user name here.
String data type
l

18.3.59.9 Networks

Lists the networks available in the area. Information listed for each network is shown as {SSID,
RSSI / Signal Strength, Channel, Security}. Sometimes areas are covered by multiple access points
configured with the same network name (SSID). In that case multiple unique access points
possessing the same network name (SSID) may be listed here.
String data type
l
Read only
l

18.3.59.10 WiFiEnable

Set to enable or disable the WiFi service. By default, WiFi is enabled. To disable, set the
Configuration option to Disable. 0 Disabled, 1 or <>0 Enabled.
Boolean data type
l

18.3.59.11 WiFiPassword

If joining a WPA or WPA2 security enabled network then this is where the passphrase is entered.
If joining a WEP security enabled network then this is where the WEP key is entered.
If creating a network and a password is supplied, the network will be created using WPA2
encryption. The password must be at least 8 characters. If a password is not supplied, an open
(unencrypted) network will be created.
When joining a network the device supports 64-bit WEP and 128-bit WEP. For 64-bit WEP enter
a 40 bit key in the form of 5 ASCII characters or 10 hexadecimal digits (0-9, A-F). For 128-bit WEP
enter a 104 bit key in the form of 13 ASCII characters or 26 hexadecimal digits (0-9, A-F).
String data type
l

18.3.59.12 WiFiPowerMode

This setting controls the power saving mode of the device. Regardless of the Power Mode setting,
the device enables power-save mode when communications are not active. Power Mode
determines how the device acts when communications are ongoing. This setting only applies
when the device is configured to Join a Network using the Configuration option.
Long data type
l
18. Information tables and settings (advanced) 181