Campbell CR300 Series Product Manual page 3

7.1 Configuring the data logger to host a Wi-Fi network
7.2 Connecting your computer to the data logger over Wi-Fi
7.3 Setting up Wi-Fi communications between the data logger and the data logger
support software
7.4 Configuring data loggers to join a Wi-Fi network
7.5 Wi-Fi LED indicator
8. Cellular communications option
8.1 Pre-installation
8.1.1 Establish cellular service
8.1.1.1 Selecting a data service
8.1.2 Install the SIM card
8.1.3 Konect PakBus Router setup
8.1.3.1 Get started
8.1.3.2 Set up Konect PakBus Router
8.2 Installation
8.2.1 Modules using Konect PakBus Router (private dynamic IP)
8.2.1.1 Configure data logger
8.2.1.2 Set up LoggerNet
8.2.1.3 Test the connection
8.2.2 Modules using a public static IP
8.2.2.1 Configure data logger
8.2.2.2 Set up LoggerNet
8.2.2.3 Test the connection
8.3 Cellular (TX/RX) LED Indicator
8.4 Signal strength
9. Radio communications option
9.1 Configuration options
9.2 RF407-Series radio communications with one or more data loggers
9.2.1 Configuring the RF407-Series radio
9.2.2 Setting up communications between the RF407-Series data logger and the
computer
9.3 RF407-Series radio communications with multiple data loggers using one data
logger as a router
9.3.1 Configuring the RF407-Series radio
9.3.2 Configuring the data logger acting as a router
9.3.2.1 Adding routing data logger to LoggerNet network
Table of Contents - ii
25
26
26
27
28
29
29
30
30
30
31
31
32
33
33
33
35
37
37
37
38
40
41
41
42
43
43
44
44
46
46
47
47