Pakbusaddress; Pakbusencryptionkey; Pakbusnodes; Pakbusport - Campbell CR300 Series Product Manual

18.3.29 PakBusAddress

This setting specifies the PakBus address for this device. Valid values are in the range 1 to 4094.
The value for this setting must be chosen such that the address of the device will be unique in
the scope of the data logger network. Duplication of PakBus addresses can lead to failures and
unpredictable behavior in the PakBus network.
When a device has an allowed neighbor list for a port, any device that has an address greater
than or equal to 4000 will be allowed to connect to that device regardless of the allowed
neighbor list.

18.3.30 PakBusEncryptionKey

This setting specifies text that will be used to generate the key for encrypting PakBus messages
sent or received by this data logger. If this value is specified as an empty string, the data logger
will not use PakBus encryption. If this value is specified as a non-empty string, however, the data
logger will not respond to any PakBus message unless that message has been encrypted.
String data type
l

18.3.31 PakBusNodes

Discontinued; aliased to CommsMemAlloc

18.3.32 PakBusPort

This setting specifies the TCP service port for PakBus communications with the data logger.
Unless firewall issues exist, this setting probably does not need to be changed from its default
value. Default 6785.

18.3.33 PakBusTCPClients

This setting specifies outgoing PakBus/TCP connections that the data logger should maintain.
Up to four addresses can be specified.
String data type
l

18.3.34 PakBusTCPEnabled

By default, PakBus TCP communications are enabled. To disable PakBus TCP communications,
set the PakBusPort setting to 65535.
18. Information tables and settings (advanced) 164