Pakbustcppassword; Pingenabled; Pppdial; Pppdialresponse - Campbell CR300 Series Product Manual

18.3.35 PakBusTCPPassword

This setting specifies a password that, if not empty, will make the data logger authenticate any
incoming or outgoing PakBus/TCP connection. This type of authentication is similar to that used
by CRAM-MD5.
String data type
l

18.3.36 PingEnabled

Set to one to enable the ICMP ping service.

18.3.37 pppDial

Specifies the dial string that would follow the ATD command (#777 for the Redwing CDMA).
Alternatively, this value can specify a list of AT commands where each command is separated by a
semi-colon (;). When specified in this fashion, the data logger will transmit the string up to the
semicolon, transmit a carriage return to the modem, and wait for two seconds before proceeding
with the rest of the dial string (or up to the next semicolon). If multiple semicolons are specified
in succession, the data logger will add a delay of one second for each additional semicolon.
If a value of PPP is specified for this setting, will configure the data logger to act as a PPP client
without any modem dialing. Finally, an empty string (the default) will configure the data logger
to listen for incoming PPP connections also without any modem dialing.
String data type
l

18.3.38 pppDialResponse

Specifies the response expected after dialing a modem before a PPP connection can be
established.
String data type
l

18.3.39 pppInfo

Reports the IP address, network mask, and default gateway for each of the data logger's active
network interfaces. If DHCP is used for the interface, this setting will report the value that was
configured by the DHCP server.
String data type
l
Read only
l
18. Information tables and settings (advanced) 165