Test The Connection; Modules Using A Public Static Ip; Configure Data Logger - Campbell CR300 Series Product Manual

8.2.1.3 Test the connection

Use the Connect screen to test the connection. Click on the appropriate station and click
Connect to initiate a call to the data logger. The data logger must have 12 V power.
TIP:
The connection time is subject to many external factors. It is often less than 30 seconds but
could be up to 15 minutes. Be patient.
If the connection is successful, the connectors at the bottom of the screen will come together and
clock information from the data logger will be displayed in the Station Date/Time field. If the
connection fails, a Communications Failure message will be displayed.

8.2.2 Modules using a public static IP

8.2.2.1 Configure data logger

8.2.2.2 Set up LoggerNet
8.2.2.3 Test the connection
8.2.2.1 Configure data logger
1. Connect the cellular antenna, if it is not already connected. When using a MIMO antenna
with multiple cellular connections, connect the primary cable to Cellular and the secondary
to Diversity. If the cables are not marked in this way, they can be connected to either
antennna port.
2. Connect to your data logger by using Device Configuration Utility.
3. (Optional) If your cellular carrier requires user name and password authentication, on the
Settings Editor > Cellular tab, set PDP Authentication Type, PPP Authentication Username
and PPP Authentication Password.
37
38
40
8. Cellular communications option 37