Radiotxpwr; Wi-Fi Settings; Ipaddresswifi; Ipgatewaywifi - Campbell CR300 Series Product Manual

18.3.58.15 RadioTxPwr

Specifies the power level at which the RF module transmits.
Levels are approximate. It is very important that the TX power level selected and the gain of the
attached antenna do not exceed the maximum allowed ERP permitted by local laws. These rules
vary from region to region.
Long data type
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Radio TX Power Level
l

18.3.59 Wi-Fi settings

Access Wi-Fi settings, using Device Configuration Utility. Clicking on a setting in Device
Configuration Utility also provides information about that setting. These settings are available for
data loggers with integrated WIFI modules.
Where to find:
All settings: Settings Editor tab in Device Configuration Utility: Wi-Fi tab.
l
Key settings: in Device Configuration Utility: Deployment > Wi-Fi tab.
l
See also Wi-Fi communications option
NOTE:
A list of Settings fieldnames is also available from the data logger terminal mode using
command F.

18.3.59.1 IPAddressWiFi

Specifies the IP address for the Wi-Fi Interface. If specified as zero, the address, net mask, and
gateway will be configured automatically using DHCP.
String data type
l

18.3.59.2 IPGatewayWiFi

Specifies the address of the IP router to which the data logger will forward all non-local IP
packets for which it has no route.
String data type
l
(p. 25)
18. Information tables and settings (advanced) 179