Ipmaskwifi; Wifichannel; Wificonfig; Wifieapmethod - Campbell CR300 Series Product Manual

18.3.59.3 IPMaskWiFi

Specifies the subnet mask for the WiFi interface.
String data type
l

18.3.59.4 WiFiChannel

This setting is only applicable when the device is configured to create a network (Configuration).
It then specifies in which channel the network should be created. If Auto is selected, the device
will select to operate on a channel that has minimal interference from other networks detected in
the area. When manually selecting a channel, it should be noted that two Wi-Fi networks
operating on the same channel will interfere with each other and will have to compete for
bandwidth. The center frequencies of adjacent channels are 5 MHz apart and the bandwidth of
each channel is 20 MHz which means that adjacent channels overlap. To completely avoid
interference there must be a spacing of at least 5 channels between each Wi-Fi network. It is
therefore recommended to use channels 1, 6, and 11.
Long data type
l

18.3.59.5 WiFiConfig

Configure the WiFi network. Join, create, or disable network.
Long data type, where:
l
0 = Join network
o
1 = Create network
o
4 = Disable network
o

18.3.59.6 WiFiEAPMethod

The EAP Method must be chosen to match the EAP method being used by the Enterprise Security
network. The inner EAP Methods supported are MSCHAPv2, MSCHAP, CHAP, and PAP.
Long data type
l

18.3.59.7 WiFiEAPPassword

If joining an Enterprise Security-enabled network enter password here.
String data type
l
18. Information tables and settings (advanced) 180