Installing The New Waste Toner Pack; Replacing The Fuser Unit And Transfer Roller Kit - MINOLTA-QMS 2200 User Manual

Installing the New Waste Toner Pack

1
Remove the new waste toner pack from the drum kit box.
2
Insert the bottom of the waste toner pack
its installation position in the printer.
3
Insert the top of the waste toner pack
into its installation position in the printer until it
is firmly seated.
4
Close the printer's front cover.
If the waste toner pack is not correctly installed
or the transfer belt right release lever is at its
top position (12 o'clock), the front cover cannot
be closed.
5
Turn on the printer.
6
Check the status message in the message window.
If an OPC drum or waste toner alert message is displayed, use the Service/Clear
care menu to remove it.

Replacing the Fuser Unit and Transfer Roller Kit

WARNING!
The fuser unit is hot. When the top cover is opened, the fuser unit temperature
drops gradually (one hour wait time). Do not replace the fuser oil roller until you
are sure that the fuser unit has cooled down.
When the fuser is worn out, the message "REPLACE FUSER UNIT" appears, and the
printer does not print. Replace the fuser kit.
16
into
Replacing the Fuser Unit and Transfer Roller Kit