Perc; Removing The Perc Riser; Installing The Perc Riser - Dell EMC PowerEdge xe7100 Installation And Service Manual

PERC

Removing the PERC riser

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
3. Remove the expander
Steps
1. Using the Phillips #2 screwdriver, remove the screw that secure the PERC riser to the expander module.
2. Lift the PERC riser from the expander module.
Figure 57. Removing the PERC riser
Next steps
Replace the PERC riser.

Installing the PERC riser

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
Steps
1. Holding the edges or the touch points, align the screw holes on the riser bracket with the screw hole on the expander
module.
2. Lower the PERC riser and press until the module clicks into place.
3. Tighten the screw to secure the PERC riser to the expander module.
54 Installing and removing enclosure components
safety instructions.
Before working inside your
module.
safety instructions.
Before working inside your
system.
system.