Figure 46. 10 x 2.5-inch with NVMe
Front PERC module
Removing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Pull the front PERC module to disengage from the connector on the drive backplane.
Next steps
1.
Replace the front mounting front PERC
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the drive backplane
4. If installed,
remove the air
5. Route the cable properly to prevent the cable from being pinched or crimped.
66
Installing and removing system components
Safety
instructions.
Before working inside your
cover.
shroud.
module.
Safety
instructions.
Before working inside your
cover.
shroud.
system.
system.