Front Perc Module; Removing The Front Mounting Front Perc Module - Dell EMC PowerEdge R7525 Installation And Service Manual

Figure 65. Installing the rear drive cage
Next steps
1. Replace the expansion card
2. Connect all the cables to the rear drive cage.
3. Install all the drives.
4. Follow the procedure listed in

Front PERC module

Removing the front mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. remove the backplane
4. If installed, remove the air
5. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide and pull the front PERC module to disengage from the connector on the drive backplane.
66 Installing and removing system components
riser, if needed.
After working inside your system
Safety instructions
Before working inside your system
cover.
shroud.
on page 27.
on page 26.
on page 27.