Figure 44. Installing the expansion card in the expansion card riser
Next steps
1.
Install the expansion card
2. Follow the procedure listed in the
Storage controller card
Removing the PERC card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Remove the screw securing the blue release latch.
2. Rotate the blue release latch to disengage it from the PERC card.
3. Push the blue release latch until the tab on the latch clicks into the slot on the chassis.
4. Hold the PERC card by the edges and pull it to disconnect it from the connector on the system board.
5. Flip the PERC card and disconnect the cable from the PERC card.
46
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.