Table of Contents
Advertisement
Steps
1. Align the slots on the PIB with the hook on the PSU cage and slide it into place.
2. Using Phillips #2 screwdriver, tighten the screws to secure the PIB to the system.
Figure 90. Installing the power interposer board
3. Route the cables and connect it to the system board.
Next steps
1.
Install the
PSU.
2.
Install the air
shroud.
3. Follow the procedure listed in
System board
Remove the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create
a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your drives.
•
Follow the safety guidelines listed in the
•
Follow the procedure listed in the
•
Remove the following components:
○
Air shroud
○
Expansion cards
○
Expansion card risers
○
Mini PERC card
○
IDSDM module
○
Internal USB key (if installed)
○
Processor
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
115
Advertisement
Table of Contents
