Installing The Power Interposer Board - Dell EMC PowerEdge R6400 Installation And Service Manual

Figure 36. Removing the midplane power cables from the PIB
Next step
Install the PIB.
Related links
Removing a power supply unit

Installing the power interposer board

Installing the power interposer board
Prerequisite
WARNING: Allow the power interposer board (PIB) to discharge after you power off the system. Handle the PIB by the edges
and avoid touching the contact surfaces of the connectors.
1 Follow the safety guidelines listed in
Steps
1 Using the Phillips #2 screwdriver, replace the screws that secure the midplane power cable to the PIB.
58 Installing and removing enclosure components
Safety instructions.