Table of Contents
Advertisement
Figure 122. Removing the power interposer board
Next steps
1.
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the power supply
4.
Remove the air
shroud.
Steps
1. Align the slots on the power interposer board (PIB) with the hooks on the PSU cage and press the PIB until the blue retention tab
clicks into place.
2. Using a Phillips #2 screwdriver, replace the screw that secures the PIB to the chassis.
3. Connect the cables to the system board and the drive backplane.
NOTE:
Route the cables properly when you replace the PIB to prevent the cable from being pinched or crimped.
132
Installing and removing system components
board.
Safety instructions
Before working inside your system
units.
on page 43.
on page 44.
Advertisement
Table of Contents
