Power interposer board
Removing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the support
bar.
4.
Remove the air
shrouds.
5.
Remove the power supply
6.
Remove the expansion card riser
Steps
1. Use Phillips #2 screwdriver to loosen the captive screw that secures the power interposer board (PIB).
2. Disconnect the cables connected from the power interposer board (PIB) to the system board.
NOTE:
Observe the routing of the cable as you remove it from the system. Route the cable properly when you
replace it to prevent the cable from being pinched or crimped.
3. Hold the touch point firmly, and slide the power interposer board up and lift it out of the system.
Figure 111. Removing the power interposer board
Next steps
1.
Replace the power interposer
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in
Safety
instructions.
Before working inside your
units.
2.
board.
Safety
instructions.
system.
Installing and removing system components
143