b
For easier handling, peel of a small section of the adhesive cover and align the mylar foam with the system cover.
c
Remove rest of the adhesive cover and install mylar foam on the system cover.
d
Press along the length of the mylar foam to ensure that it is rmly aixed to the system cover.
Figure 88. Installing mylar foam on the system cover
3
Follow the procedure listed in
IDSDM/vFlash card (optional)
The IDSDM/vFlash card combines the IDSDM and/or vFlash features into a single module.
Removing the micro SD card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the SD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot.
2
Hold the SD card and remove it from the slot.
NOTE:
Temporarily label each SD card with its corresponding slot number after removal.
Next step
Install a micro SD card.
Related link
Installing the micro SD card
Installing the micro SD card
Prerequisites
Follow the safety guidelines listed in
134
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
Safety
instructions.
system.