Internal Sd Card; Removing An Internal Sd Card; Installing An Internal Sd Card; Integrated Storage Controller Card - Dell EMC PowerEdge R620 Owner's Manual

Internal SD card

Removing an internal SD card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2 Open the system.
3 Locate the SD card slot on the internal dual SD module or the backplane expander board and press inward on the card to release it
from the slot and remove the card.
4 Close the system.
5 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing an internal SD card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: To use an SD card with your system, ensure that the internal SD card port is enabled in the System Setup.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2 Open the system.
3 Locate the SD card connector on the internal dual SD module or the backplane expander board. With the label side facing up, insert
the contact-pin end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
4 Press the card into the card slot to lock it into place.
5 Close the system.
6 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Integrated storage controller card

Your system includes a dedicated expansion card slot on the system board for an integrated storage controller card. The integrated storage
controller card provides the integrated storage subsystem for the internal hard drives in your system.The controller supports SAS and SATA
hard drives and also enables you to set up the hard drives in RAID configurations. The RAID configurations depend on the version of the
storage controller included with your system. The controller supports SAS hard drives.
64 Installing and removing system components