Table of Contents
Advertisement
Figure 63. Installing an expansion card into a low profile left riser
Figure 64. Installing an expansion card into a low profile right riser
Next steps
1. If applicable, connect the cables to the expansion card.
2.
Install the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more
information about the Part replacement configuration, see the
idracmanuals
Micro SD card
After working inside your
system.
Lifecycle Controller User's Guide at
Installing and removing system components
www.dell.com/
79
Advertisement
Table of Contents
