Mitsubishi Electric MELIPC MI5000 Series User Manual page 68

Window
Confirm cyclic transmission status in "Link status".
■Execution procedure
1.
In the "CC-Link IE Field diagnoses" window, click the [Link start/stop] button.
2.
In "Selection status", select the station for which to start or stop cyclic transmission.
If the station connected to MI Configurator is a local station, only the own station can be selected. The connected station can
be checked in "Connected Station Information".
3.
In "Link start/stop run details", select whether to start or stop cyclic transmission.
If "Perform forced link start" is selected, then forced cyclic transmission can be started for stations that have had cyclic
transmissions stopped from other stations, or from Link special relay (SB) and Link special register (SW).
4.
Click the [Execute] button.
■If the product has been reset or the power turned OFF to ON
Even if cyclic transmission has been stopped through Link stop, if the product is reset or power turned OFF→ON, then cyclic
transmission will restart.
■If link stopped to error disabled stations or temporary error disabled stations
Be aware that stations that stopped a link are displayed as data linking in the CC-Link IE Field Network diagnosis. If links were
stopped to error disabled stations or temporary error disabled stations, confirm the stoppage by checking that 'Data link stop
status of own station' (SB0049) is ON.
■Stations that cannot start link
In the following cases, link start is not possible.
• Stations that have stopped cyclic transmission because of an error
• Stations that are link stopped because of a link stop in another station
• Stations that are link stopped because of Link special relay (SB) and Link special register (SW).
*1 If "Perform forced link start" is selected, then link start is possible.
6 CC-Link IE Field Network FUNCTION
66
6.4 CC-Link IE Field Network diagnosis
*1
*1