Mitsubishi Electric MELIPC MI5000 Series User Manual page 197

18.2
Network Configuration Settings
The following shows the procedure for setting a network configuration.
1.
From "Module List", select the external device to be connected, and then drag and drop (3) it to "Device List" (1) or
"Device Configuration" (2).
(1)
(2)
This product does not support sub master stations. Accordingly, from "Unit List" "Master/local module",
modules that are master module only cannot be used as the station type.
2.
Set each item.
3.
Click the [Reflect and Close the Setting] button.
Displayed items
Item
Header I/O
[Detect Now] button
Mode Setting
Assignment Method
Link Scan Time (Approx.)
No.
Model Name
STA#
Description
Displays the header I/O No.
(For this product, the header I/O No. is 3E00.)
Automatically read slave station information.
(iQ Sensor Solution Reference Manual)
Displays the master station mode.
Select the link device assignment method.
• Point/Start: Enter the points and start numbers of link devices.
• Start/End: Enter the start and end numbers of link devices.
Displays the approximate value for the link scan time.
Displays the number of slave stations set in "Network topology
settings".
Displays the module model name.
For modules not registered in the profile, select from generic CC IE
Field Modules, or register with the profile and then set. For details on
profile registration methods, refer to the following.
MI Configurator Operating Manual
Set the station numbers for slave stations to connect to the network.
Set station numbers do not need to be consecutive. (Duplication not
allowed)
Setting range Parameter
No.



• Point/Start
• Start/End
(Default: Start/End)



1 to 120 A044H
(Default: Lowest number
amongst blank numbers)
(Master station fixed at
"0")
18 APPRICATION PARAMETERS
18.2 Network Configuration Settings
18
195