Mitsubishi Electric MELIPC MI5000 Series User Manual page 232

Error code
4033H
4041H
4042H
4043H
4044H
4051H
4052H
4053H
4054H
4080H
4081H
4082H
408BH
4100H
4105H
410CH
4110H
4121H
4122H
4125H
4126H
4127H
4128H
APPX
230
Appendix 2 List of Error Codes
Error name
Device specification error
CC-Link IE Field function
specification error
CC-Link IE Field function
specification error
CC-Link IE Field function
specification error
CC-Link IE Field function
specification error
Protect error
Protect error
Protect error
Protect error
Any other error
Any other error
Any other error
Any other error
Any other error
Any other error
Any other error
MELIPC related error
File related error
File related error
File related error
File related error
File related error
File related error
Description
The specified device is full system use, and
therefore cannot be written.
The access range exceeds the buffer
memory range.
Buffer memory cannot be accessed.
The specified I/O number or network No. is
different.
Buffer memory cannot be accessed.
The specified drive (memory) cannot be
accessed.
A request was issued to the system file.
An error occurred when writing data to the
specified drive (memory).
An error occurred when deleting data from
the specified drive (memory).
Request data error.
File header information does not exist.
The specified command cannot be
executed since it is being executed.
The remote request cannot be executed.
MELIPC hardware fault.
MELIPC hardware fault.
Writing to the specified data is not
supported.
The MELIPC is in a stop error status and
cannot execute the request content.
The specified drive (memory) or file does
not exist.
The specified drive (memory) or file does
not exist.
The specified drive (memory) or file is
performing processing.
The specified drive (memory) or file is
performing processing.
File password mismatch.
File password mismatch with copy
destination.
Corrective action
Do not write data to the specified device. Or,
do not turn it ON/OFF.
Check the header address and access point
numbers, and access buffer memory that is
within the CC-Link IE Field Network function
range.
After resetting the MELIPC, execute a
request again. If the same error is displayed
again, this may indicate a hardware fault.
Consult your local Mitsubishi
representative.
Review the specified I/O number or network
No., and execute again.
After resetting the MELIPC, execute a
request again. If the same error is displayed
again, this may indicate a hardware fault.
Consult your local Mitsubishi
representative.
Check the following points, and then take
action.
• Is the drive (memory) the one that can be
used?
• Is the specified drive memory correctly
inserted?
Check command data such as SLMP.
Check command data such as SLMP.
Check command data such as SLMP.
Check the specified request data.
Reread the parameter, and reset the
MELIPC. If the same error is displayed
again, this may indicate a hardware fault.
Consult your local Mitsubishi
representative.
Execute the command again once the
request from another engineering tool has
been completed.
• Execute the request again after placing
the MELIPC in the state in which a
remote request can be executed.
• For a remote reset operation, enable
remote resets in the parameters.
Replace the MELIPC.
Replace the MELIPC.
• Check that the version of the engineering
tool used is correct.
• Check the settings and make a
correction.
After resetting the MELIPC, execute a
request again.
Execute again after checking the specified
drive (memory) or file.
Execute again after checking the specified
drive (memory) or file.
Execute it again after a while.
Execute it again after a while.
File password mismatch.
Execute again after checking the file
password.