Mitsubishi Electric MELIPC MI5000 Series User Manual page 257

Event code Event type
534H System
535H System
541H System
542H System
800H System
C00H System
C01H System
C02H System
C10H System
C11H System
C20H System
C21H System
C22H System
C24H System
C25H System
C27H System
20011H Operation
24000H Operation
24001H Operation
24010H Operation
24011H Operation
24020H Operation
24021H Operation
24030H Operation
24100H Operation
24F00H Operation
Event category Event
Information <<Other station>> Reserved
station temporary clear settings
execute
Information <<Own station>> Reserved
station enabled settings
instruction execute
Information Reception parameter error clear
Information <<Own station>> Reception
frame error, circuit status caution
level
Warning Link-down
Warning <<Own station>> Baton pass
interruption
Warning <<Other station>> Baton pass
interruption
Warning Other station access faulty
response
Warning <<Own station>> Data link stop
Warning <<Other station>> Data link stop
Warning <<Other station>> parameter
error occurred
Warning <<Other station>> Error
occurrence
Warning Station duplication occurred
Warning <<Other station>> Receive frame
error occurred
Warning Reception parameter error
occurred
Warning Transient reception failure
Information CC-Link IE Field Network
Parameter changed
Information Data link start instruction
Information Data link stop instruction
Information Temporary error disabled station
settings instruction
Information Temporary error disabled station
clear instruction
Information Reserved station temporary clear
settings instruction
Information Reserved station temporary
enabled settings instruction
Information Network number, station number
settings change instruction
execution
Information <<Own station>> Parameter
change/new parameter received
Information <<Own station>> CPU operating
status change detection
Description
Other station reserved station temporary clear
settings carried out.
Other station reserved station enabled settings
carried out.
Error of parameter received from master station /
control station was cleared. (Normal parameter was
received)
Reception frame error (Circuit status: Caution level)
occurred.
The CPU module has entered into the link-down
state as a result of an operation such as removing a
network cable connected to an external device.
Own station baton pass interrupted.
Other station baton pass interrupted.
• At other station access, a faulty response was
returned from the other station.
• At access from the other station, a faulty response
was returned to the other station.
Own station data link stopped.
Other station data link stopped.
Parameter error occurred in other station.
An error occurred on another station.
Master station or slave station duplication occurred
on the network.
Reception frame error occurred on another station.
Error detected in parameter received from master
station/administered station.
Own station transient frequency is too high,
therefore transient reception failed.
CC-Link IE Field Network Parameters have been
changed.
Data link start instruction to station or other station.
Data link stop instruction to station or other station.
Temporary error disabled station settings instruction
to slave station
Temporary error disabled station clear instruction to
slave station.
Reserved station temporary clear settings instruction
to slave station.
Reserved station temporary settings instruction to
slave station.
Network number, station number settings change
instruction for slave station given.
A parameter was changed. Alternatively, a new
parameter was received when the power supply was
turned ON.
Other station programmable controller CPU
operation status changed.
Appendix 3 Event List
A
APPX
255