Messages And Parameters - Siemens SINAMICS S120 Function Manual

4. The current speed setpoint in the ramp-function generator is then set to the current actual
speed value.
The ramp-up to the final speed setpoint starts with this value.
Bit r1205.21 indicates whether flying restart is active.
5. The search current and the search speed can be set using parameters p1202 and p1203 to
optimize the flying restart.
Note
If the search current is changed (p1202), then a stationary measurement must be carried
out to accept the change. After changing the parameter, the measurement is configured
(p1909.22 = 1) so that it is as short as possible. The bit is only reset if a motor data
identification routine has been carried out.
6.17.3

Messages and parameters

Overview of important faults (see SINAMICS S120/S150 List Manual)
● F07330
● F07331
Overview of important parameters (see SINAMICS S120/S150 List Manual)
● p0247
● p0352[0...n]
● p1082[0...n]
● p1200[0...n]
● p1202[0...n]
● p1203[0...n]
● r1204.0...15
● r1205.0...21
● p1780.11
● p1900
● p1909[0...n]
Drive functions
Function Manual, 06/2019, 6SL3097-5AB00-0BP2
Flying restart: Detection current measured too low
Flying restart: Function not supported
Voltage measurement configuration
Cable resistance
Maximum speed
Flying restart operating mode
Flying restart detection current
Flying restart search rate factor
CO/BO: Flying restart, V/f control status
CO/BO: Flying restart, vector control status
Motor model adaptation configuration
Fast flying restart with voltage model for induction machines
Motor data identification and rotating measurement
Motor data identification control word
Vector control
6.17 Flying restart
271