Siemens SINAMICS S120 Function Manual page 765

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Via the web server

● Message A13030 "Trial License activated"

● System > Licenses

Insufficient licensing

Operation without an adequate license is only permissible when commissioning the drive

and when carrying out service work. To do this, activate the Trial License Mode

The drive requires a sufficient license in order for it to operate.

There is a common Trial License Mode for most functions requiring a license. Using the Trial

License Mode, you can try out these functions until you actually purchase the licenses.

The Trial License Mode encompasses three periods, each with 300 operating hours of the

drive. You must separately start each period of the Trial License Mode.

If the last period of the Trial License Mode has elapsed, the drive goes into a fault condition the

next time that it is switched on. To be able to switch on the drive again, you must either activate

the functions that require a license or enter a valid license key.

Use the Trial License

In order to use trial license mode, proceed as follows.

1. Select "System > Licenses" in the navigation.

2. Click "Activate Trial License Mode".

3. .Acknowledge the confirmation prompt

Message A13030 indicates that the Trial License has been activated.

After the Trial License has expired, alarm A13031 "Trial License Period expired" is output.

Repeat steps 1 and 3 if you want to activate the Trial License for another trial period.

Drive functions

Function Manual, 06/2019, 6SL3097-5AB00-0BP2

13.6 System settings