Installation; Control Computer Ports - 3D Histech Pannoramic 250 FLASH II User Manual

Pannoramic 250 FLASH II 1.18.1.1 User's Guide

2 Installation

The installation of Pannoramic 250 FLASH II must be carried out by
trained professionals! In any other case the warranty will be
automatically voided.
Supplier/Distributor is not liable for any damages caused by an
installation that is not carried out by a professional person.
Only qualified service assistants are allowed to install the hardware and software. The product is
ready for use after installation.

2.1 Control computer ports

The following figure shows the location of the connectors in order to enable easier transportation of
the product for a short distance, by disconnecting cables and detaching hardware components from
each other.
May 29, 2014 – Rev. 1
Warning!
Figure 7 – Ports on control computer
3DHISTECH Ltd.
2 Installation
24(137)