Focus Panel; Service Panel - 3D Histech Pannoramic 250 FLASH II User Manual

Pannoramic 250 FLASH II 1.18.1 User's Guide
The Preview panel offers options for threshold setting and selection of the area to be scanned. The
options in Automatic mode are the same as described in Manual mode.
In Automatic mode you cannot change the threshold values (it will use the threshold values that were
set previously in the Manual mode), and when activating the Use selection box option, the area
cannot be set.
For more information, see section 4.5.3. Preview panel.
It is recommended to use profiles, since the Automatic mode does not
provide a preview image to check settings.

4.6.4 Focus panel

Focus
You can define focus limits by selecting Limit focus range checkbox. You can set the upper
and lower limits by selecting the desired value in the selection boxes.
This is useful if focusing was not targeted on the specimen, but on a spot on the coverslip.

4.6.5 Service panel

May 29, 2014 – Rev. 1
Note:
Figure 73 – Focus panel
Figure 74 – Service panel
3DHISTECH Ltd.
4 Software Description
107(137)