3D Histech Pannoramic 250 FLASH II User Manual page 124

Pannoramic 250 FLASH II 1.18.1 User's Guide
4. Loosen pressure bolt with the lever (1) and by keeping the lever pressed, remove lamp
module (2) (see Figure 91).
5. Carefully retrieve the new lamp module from its transporting container. Hold the lamp
module only by its ceramic part.
6. Insert the new lamp module. Make sure that the groove (1) in the contact surface of the
lamp captures the corresponding pin of the lamp mount (see Figure 92).
Incorrect handling may considerably reduce the lamp module's useful
life. Hold it by the ceramic part in all cases! Never touch the lamp's
glass surface or the inside surface of the reflector. Skin oil is harmful to
these parts.
7. Tighten pressure bolt again with the lever (Figure 90 – 1).
8. Re-establish plug-in connection.
9. Screw the lateral cover-plate down to the housing.
May 29, 2014 – Rev. 1
Figure 91 – Removing the lamp module
Figure 92 – Inserting the lamp module
Caution!
3DHISTECH Ltd.
5 Troubleshooting and Maintenance
124(137)