3D Histech Pannoramic 250 FLASH II User Manual page 10

Pannoramic 250 FLASH II 1.18.1 User's Guide
Warning!
Warning!
Caution!
Crush hazard!
Warning!
Warning!
Warning!
Warning!
May 29, 2014 – Rev. 1
Use only electric fuses which are rated for the specified nominal current. You
are prohibited from using makeshift fuses or short-circuiting of a fuse holder.
The Pannoramic 250 FLASH II does not include any special facilities to protect
from samples with an etching, potentially infectious, toxic, radioactive or other
health-damaging effect. You are under obligation to comply with all currently
binding legislation, notably, national accident prevention rules when handling
samples of this kind.
Dirt or dust may adversely impact the operating capability of the Pannoramic
250 FLASH II. For this reason, measures must be taken to eliminate such
influences to a maximum possible degree. During periods of non-use, the
Pannoramic 250 FLASH II must be protected with a dust cover. Check that power
is turned off before you put the cover on.
There is crush hazard in the movement area of the slide insert during operation.
Please note that the digitizing process has to be interrupted and the insert
moved via software to the output position before removing the insert.
Clogged or covered ventilation slots may result in a heat build-up with a
damaging effect for the Pannoramic 250 FLASH II. In extreme cases, this may
also cause fire. Keep the ventilation slots always unobstructed and refrain from
inserting or dropping objects into a ventilation slot.
A defective Pannoramic 250 FLASH II is not classified as domestic waste. It must
be properly disposed in accordance with currently valid legal requirements.
The Pannoramic 250 FLASH II may not be operated by other than properly
instructed persons. Operating personnel must be fully aware of the potential
dangers which a particular field of application involves. The Pannoramic 250
FLASH II is a precision instrument which may suffer a significant reduction in
operational functions or even physical destruction following intervention
performed in any nonconforming manner.
If an HXP 120 illumination unit is used, the corresponding warnings included in
the manufacturer's operating manual have to be observed.
3DHISTECH Ltd.
Notes Regarding Operational Safety
10(137)