Insert And Remove Magazines - 3D Histech Pannoramic 250 FLASH II User Manual

Pannoramic 250 FLASH II 1.18.1 User's Guide
Only original 3DHISTECH P250 magazines are allowed for use with Pannoramic 250 FLASH II!
The magazines can contain a maximum of 25 slides.
Push slide (1) into the magazine (3) with its barcode end (2) first. The symbols on the side of
•
the magazine demonstrate the proper way of inserting slides. The magazine and its proper
insertion is identified by a sensor in the main unit upon actuating it by the magnet in the
side of the magazine (4).
You should insert several slides into a magazine without empty slots.
Begin the insertion on position 1 of the magazine.
To insert or remove a filled magazine from the device, or when
transporting it without its cover (5), slightly tilt it to its closed side to
prevent the slides from accidentally falling out. Magazines should
always be kept clean from dust, broken glass and other mounting
media residues. Slide loader will only operate safely and properly, if
magazines are clean.

3.3.2 Insert and remove magazines

May 29, 2014 – Rev. 1
Note:
Caution!
Figure 14 – Inserting a magazine
3DHISTECH Ltd.
3 Operating Slides and Magazines
32(137)