Cleaning The Device; Cleaning The Magazine; Preventive Maintenance - 3D Histech Pannoramic 250 FLASH II User Manual

Pannoramic 250 FLASH II 1.18.1 User's Guide
When the HXP 120 illumination unit is switched on:
•
Never look directly into the fiber-optic cable.
◦
Never remove the fiber-optic cable from the device.
◦
Never connect the fiber-optic cable to the device.
◦
Never remove the housing from the device.
◦

5.1.1 Cleaning the device

Before cleaning, switch off the device and pull the plug out.
•
Do not let liquid penetrate into the system.
•
To clean liquid from the device, use a lint-free cotton cloth. You can moisten the cloth with
•
water.
To clean greasy surfaces, it is recommended to apply Isopropanol or Ethanol on a piece of
•
lint-free cotton cloth and gently rub the surface.

5.1.2 Cleaning the magazine

Do not clean the magazines with xylene, because it might harm the plastic. We recommend to apply
Isopropanol or Ethanol on a piece of lint-free cotton cloth and gently rub the surface instead. In case
the magazine is damaged, use either order a new one, as inserting a deteriorated magazine could
lead into unsafe loading of slides.

5.1.3 Preventive maintenance

To prevent fungal growth
Do not leave the equipment in an unconditioned environment with a storage temperature
•
above 60°C (140°F) or below 0°C (32°F), which may damage the equipment.
Maximum operating temperature is 35°C (95°F) with a relative humidity of less than 75%.
•
Install it in a room with proper air ventilation.
•
Do not let dust or fingerprints remain on optical surfaces.
•
May 29, 2014 – Rev. 1 3DHISTECH Ltd.
5 Troubleshooting and Maintenance
117(137)