Affixing Barcode Stickers To Slides - 3D Histech Pannoramic 250 FLASH II User Manual

Pannoramic 250 FLASH II 1.18.1 User's Guide
Fluorescent signals become more easily detectable for the scanner,
therefore resulting in a brighter and better image, by treating the slide
with a formula that prevents rapid photobleaching of fluorescent
reagents (e.g. VECTASHIELD® Fluorescent Mounting Medium by Vector
Laboratories and ProLong® Gold and SlowFade® Gold antifade reagents
by Invitrogen) during the FISH protocol.
For further information, see the homepages of the manufacturers:
http://www.vectorlabs.com/

3.2 Affixing Barcode Stickers to Slides

This section describes how to affix barcode stickers to slides. Barcodes enable virtual slide
identification.
The label area (1) is recorded by the preview camera, and can be displayed by the control and viewer
software.
To affix barcode stickers to slides, do the following:
1. Peel off the barcode sticker (2) from the roll.
2. Stick it on the colored label area of the slide (1), on the specimen side.
May 29, 2014 – Rev. 1
Note:
and http://www.invitrogen.com.
Figure 12 – Slide with a barcode sticker
3DHISTECH Ltd.
3 Operating Slides and Magazines
30(137)